Technical Details
- DuPont Fiber braided line
- Injection molded polycarbonate spool
- Marine grade stainless steel axle
- Aircraft grade hardcoated aluminum frame
- Marine grade stainless steel double end snap
- Made in USA
RE50400 – Cave Sidewinder Primary Reel
- 400 ft (121.9 m) #24 braided line
- 220 lbs breaking strength
RE50250 – Wreck Sidewinder Primary Reel
- 50 ft (76.2 m) #36 braided line
- 350 lbs breaking strength
Tips
- Before diving with a new reel (or a dry reel that has been in storage), put the reel in a bucket of water and after soaking, pay out the entire length of line and reel it back in. This will moisten the line, precluding it from swelling on the reel and further preventing the possibility of jamming or damaging the spool.
- As with most dive equipment, you should rinse your reel with fresh water following each dive. You should also periodically disassemble the reel, and remove any build up of salt or sediment on its internal parts.
- Dive Rite recommends pulling some or all of the line off the spool before each dive, then rewinding it neatly but not too tightly, so as to prevent the possibility of jamming during line deployment.
- Too much line on the spool can cause jams during initial deployment, if you are having a problem with jams try removing 10 or 15 feet of line.
- Different line thicknesses are available for specific applications. The thicker, #36 line is preferred for use on wrecks or any environment where sharp or jagged edges are present and can contribute to line wear.
